The configuration procedures are listed below:
XGS 3-42000R(config)#interface vlan 1
XGS 3-42000R(config-if-vlan1)#ip address 10.1.1. 2 255.255. 255. 0
XGS 3-42000R(config-if-vlan1)#exit
XGS 3-42000R(config)#radius-s erver authentication host 10.1.1.3
XGS 3-42000R(config)#radius-s erver accounting host 10.1.1. 3
XGS 3-42000R(config)#radius-s erver key test
XGS 3-42000R(config)#aaa enable
XGS 3-42000R(config)#aaa-accounting enable
XGS 3-42000R(config)#dot 1x enable
XGS 3-42000R(config)#interface ethernet 1/2
XGS 3-42000R(config-If-Ethernet1/2)#dot1x enable
XGS 3-42000R(config-If-Ethernet1/2)#dot1x port-control auto
XGS 3-42000R(config-If-Ethernet1/2)#exit
47.3.3 Examples of IPv6 Radius Application
2004:1:2:3::2
2004:1:2:3::1
Radius Server
2004:1:2:3::3
IPv6 Radius
Figure 47-3-4
Connect the computer to the interface 1/2 of the switch, and enable IEEE802.1x on interface1/2. Us e MAC
based authentication. Configure the IP address of the switch as 2004:1: 2:3::2, and connect the switch with
any interface except interfac e 1/2 t o the RA DIUS authentication server. Configure the IP address of the
RADIUS server to be 2004:1:2:3::3. Use the default ports 1812 and 1813 for authentication and accounting
respectively. Install the IEEE802.1x authentication client soft ware on the comput er, and use the client for
IEEE802.1x authentication.
47-19