Planet XGS3-42000R User Manual page 50


Approved PLANET SFP Transceivers
PLANE T Chassis Switch supports both Single-mode and Multi-mode SFP transceiver. The following list of
approved PLANE T SFP transceivers is correct at the time of publication:
Gigabit SFP Transceiver modules:
■ MGB-SX SFP (1000BASE-S X SFP transceiver / Multi-mode / 850nm / 220m~550m)
■ MGB-LX SFP (1000BASE-LX SFP transceiver / Single-mode / 1310nm / 10km)
■ MGB-L30 SFP (1000BASE-LX SFP transceiver / Single-mode / 1310nm / 30km)
■ MGB-L50 SFP (1000BASE-LX SFP transceiver / Single-mode / 1310nm / 50km)
■ MGB-LA10 SFP (1000BASE-LX SFP transceiver / WDM Single-mode / TX: 1310nm, RX: 1550nm/
10km)
■ MGB-LB10 SFP (1000BASE-LX SFP transceiver / WDM Single-mode / TX: 1550nm, RX: 1310nm /
10km)
It recommends using PLA NE T SFPs on the Chassis Switch. If you insert a SFP
transceiver that is not supported, the Chassis Switch will not recognize it.
Before connect the other Chassis Switches, workstation or Media Converter.
1. Make sure both side of the SFP transceiver are with the same media type, for example: 1000Base-S X to
1000Base-S X, 1000B as-LX to 1000B ase-LX.
2. Check the fiber-optic cable type match the SFP transceiver model.

To connect to 1000Base-S X SFP transceiver, use the Multi-mode fiber cable-with one side must be
Figure 2-2-10 Plug-in the XFP transceiver
2-20