Typical Gvrp Application - Planet XGS3-42000R User Manual

14.2.3 Typical GVRP Application

Scenario:
To enable dynamic VLAN information register and updat e among switches, GVRP protocol is to be configured
in the Chassis Switch. Configure GVRP in Switch A, B and C, enable Switch B to learn VLAN100 dynamically
so that the two workstation connected to VLAN100 in Switch A and C can communicate with each other
through Switch B without static VLAN100 entries.
Configuration Item
VLAN100
Trunk port
Global GVRP
Port GVRP
Connect the two workstation to the VLAN100 ports in switch A and B, connect port 11 of S witch A to port 10 of
Switch B, and port 11 of Switch B to port 11 of Switch C.
The configuration steps are listed below:
Switch A:
XGS 3-42000R(config)# gvrp
XGS 3-42000R(config)#vlan 100
XGS 3-42000R(config-Vlan100)#switchport interface ethernet 1/2-6
XGS 3-42000R(config-Vlan100)#exit
XGS 3-42000R(config)#interface Ethernet 1/11
XGS 3-42000R(config-If-Ethernet1/11)#s witchport mode trunk
PC
Switch A
Switch C
PC
Figure 14-2-1 Typical GV RP Application Topology
Configuration description
Port 2 -6 of Switch A and C.
Port 11 of Switch A and C, Port 10, 11 of Switch B.
Switch A, B, C.
Port 11 of Switch A and C, Port 10, 11 of Switch B.
14-9
Switch B