Table of Contents
Advertisement
Interface Configuration Mode
ipv6 pim scope-border
<500-599>|<acl_name>
no ipv6 pim scope-border
（2）Configure global PIM-SM6 parameter
1) Configure the switch as a candidate BSR
Global Configuration Mode
ipv6 pim bsr-candiate {vlan
<vlan_id>|<ifname> | tunnel
<1-50>}[ha sh-ma sk-length]
[priority]
no Ipv6 pim bsr-candiate {vlan
<vlan_id>|<ifname> | tunnel
<1-50>}[ha sh-ma sk-length]
[priority]
2) Configure the switch as a candidate RP
Global Configuration Mode
ipv6 pim rp-candiate
{vlan<vlan-id>|
loopback<index> |<ifname>}
[<group range>] [<priority>]
no ipv6 pim rp-candiate
3) Configure static RP
Global Configuration Mode
ipv6 pim rp-address <rp-address>
[<group-range>]
no ipv6 pim rp-address
<rp-address> {all|<group-range>}
Command
Command
Command
To configure PIM-SM6 management boundary
for the interface and apply ACL for the
management boundary. With default settings,
ffx0::/13 is considered as the scope of the
management group. If ACL is configured, then
the scope specified by ACL permit command is
the scope of the management group. acl_name
should be standard IP v6 ACL name. The no
form
of
this
command
configuration.
Explanation
This command is the global candidate BS R
configuration command, which is used to
configure the information of PIM-SM candidate
BSR so that it can compete for BSR router with
other candidate BSR. The no operation is to
cancel the configuration of BSR.
Explanation
This command is the global candidate RP
configuration command, which is used to
configure the information of PIM-SM candidate
RP so that it can compete for RP router with
other candidate RP. The no operation is to
cancel the configuration of RP.
Explanation
To configure the address of the candidate RP.
The no form of this command will remove the
configuration for the candidate RP.
44-9
will
remove
the
Advertisement
Table of Contents
Troubleshooting
