Table of Contents
Advertisement
BSR through automatic selection.
44.2.2 PIM-SM6 Configuration Task List
1． Enable PIM-SM (Required)
2． Configure static multicast routing entries (Optional)
3． Configure additional paramet ers for PIM-SM (Optional)
(1)
Configure parameters for PIM-SM interfaces
1) Configure the interval for PIM-SM hello messages
2) Configure the holdtime for P IM-SM hello messages
3) Configure ACL for PIM-SM6 neighbors
4) Configure the interface as the boundary interface of the P IM-SM6 protocol
5) Configure the interface as the management boundary of the PIM-SM6 protocol
(2)
Configure global PIM-SM parameters
1) Configure the switch as a candidate BSR
2) Configure the switch as a candidate RP
3) Configure static RP
4． Disable the PIM-SM protocol
1. Enable PIM-SM protocol
The PIM-SM protocol can be enabled on XGS 3 series Layer 3 switches by enabling PIM6 in global
configuration mode and then enabling P IM-SM for specific interfaces in the interface configuration mode.
Global Configuration Mode
[no] ipv6 pim multicast-routing
Make the PIM-SM protocol work for specific interfaces
Interface Configuration Mode
[no] ipv6 pim sparse-mode
[passi ve]
2．Configure static multica st routing entries
Global Configuration Mode
Command
Command
Command
Explanation
To enable the PIM-SM6 protoc ol for all the
interfaces (However, in order to make PIM-SM
work
for specific interfaces, the
command should be issued). (required)
Explanation
To enable PIM-SM for the specified interface.
The no form of this command will disable the
PIM-SM protocol (required).
Explanation
44-7
following
Advertisement
Table of Contents
Troubleshooting
