Table of Contents
Advertisement
（2）Configure the RIP version to send/receive in all ports.
（3）Configure whether to enable RIP packets sending/receiving for ports
Interface configuration mode
ip rip send version { 1 | 1-compatible |
2 }
no ip rip send version
ip rip receive version {1 | 2 | }
no ip rip receive version
ip rip receive-packet
no ip rip receive-packet
ip rip send-packet
no ip rip send-packet
4. Delete the specified route in RIP route table
Admin Mode
clear ip rip route
{<A.B.C.D/M>|kernel|static|connected|r
ip|ospf|i si s|bgp|all}
5. Configure the RIP routing aggregation
（1） Configure IPv4 aggregation route globally
Rout er Configuration Mode
ip rip aggregate-address A.B.C.D/M
no ip rip aggregate-address A.B.C.D/M
（2） Configure IPv4 aggregation route on interface
Interface Configuration Mode
ip rip aggregate-address A.B.C. D/M
no ip rip aggregate-address
A.B.C. D/M
（3） Display IPv4 aggregation route information
Admin Mode and Configuration Mode
show ip rip aggregate
Command
Command
Command
Command
Command
Explanation
Sets the version of RIP packets to send on all
ports; the no ip rip send version command set
the version to the one configured by the version
command.
Sets the version of RIP packets to receive on all
ports; the no action of this command set the
version to the one configured by the version
command.
Enables receiving RIP packets on the interface;
the no ip rip receive-packet command close
data receiving on this port.
Enables sending RIP packets on the interface;
the "no ip rip send-packet" command disables
sending RIP packets on the interface.
Explanation
The command deletes a specified route from the
RIP route table.
Explanation
To configure or delete IP v4 aggregation route
globally.
Explanation
To configure or delete IP v4 aggregation route
on interface.
Explanation
To display aggregation rout e information.
35-7
Advertisement
Table of Contents
Troubleshooting
