Lldp Function Typical Example - Planet XGS3-42000R User Manual

show lldp
show lldp interface ethernet <IFNAME>
show lldp traffic
show lldp neighbors interface
ethernet < IFNAME >
show debugging lldp
Admin Mode
debug lldp
no debug lldp
debug lldp packets interface ethernet
<IFNAME>
no debug lldp packets interface ethernet
<IFNAME>
Port configuration mode
clear lldp remote-table

11.3 LLDP Function Typical Example

In the network topology graph above, the port 1,3 of SWITCH B are connected to port 2,4 of SWITCH A. Port
1 of SWITCH B is configured to message-receiving-only mode, Option TLV of port 4 of SWITCH A is
configured as portDes and SysCap.
SWITCH A configuration task sequence:
Switch A(config)# lldp enable
Switch A(config)#int erface ethernet 1/4
Switch A(Config-If-Ethernet1/4)# lldp transmit optional tlv port Desc sysCap
Switch A(Config-If-Ethernet1/4)exit
SWITCH B configuration task sequence:
Switch B(config)#lldp enable
Switch B(config)#interface ethernet1/1
Figure 11-3-1 LLDP Function Typical Configuration Example
Display the current
information.
Display the LLDP configuration information of
the current port.
Display the information of all kinds of counters.
Display the information of LLDP
of the current port.
Display all ports with LLDP debug enabled.
Enable or disable the DEBUG switch.
Enable or disable the DEB UG packet-receiving
and sending function in port or global mode.
Clear Remote-table of the port.
11-4
LLDP configuration
neighbors