Ripng Configuration Examples; Typical Ripng Examples - Planet XGS3-42000R User Manual

Command
Rout er IP v6 RIP Configuration Mode
redistribute ospf [<process-tag> ]
[metric<value> ] [route-map<word>]
no redistribute ospf [<process-tag> ]
(2)Di splay and debug the information about configuration of redi stribution of OSPFv3 routing to
RIPng
Admin Configuration Mode
show ipv6 rip redistribute
Admin Mode
debug ipv6 rip redistribute message
send
no debug ipv6 rip redistribute
message send
debug ipv6 rip redistribute route
receive
no debug ipv6 rip redistribute route
receive

36.3 RIPng Configuration Examples

36.3.1 Typical RIPng Examples

Interface VLAN1:
2000:1:1::1/64
SwitchA
Interface VLAN2:
2001:1:1::1/64
As shown in the above figure, a network consists of three layer 3 switches. SwitchA and SwitchB connect to
SwitchC through interface vlan1 and vlan2. All the three switches are running RIPng. Assume SwitchA
（VLAN1：2001:1:1::1/64 and VLAN2：2001:1:1::1/64）exchange update information with SwitchB（VLA N1：
2001:1:1::2/64） only, update information is not exchanged between SwitchA and SwitchC（V LAN1：
2001:1:1::2/64）.
The configuration for S witchA, SwitchB and SwitchC is shown below:
Command
Figure 36-3-1 RIPng Example
Explanation
To enable or disable redistribution of OSPFv3
routing for RIPng.
Explanation
To display RIPng
redistributed from other routing prot ocols.
To enable or disable debugging messages
sent by RIP ng for redistribution of OSPFv3
routing.
To enable or disable debugging route
messages received from NSM.
Interface VLAN1:
2000:1:1::2/64
Interface VLAN1:
2001:1:1::2/64
36-6
routing which is
SwitchC
SwitchB