Planet XGS3-42000R User Manual page 422

1. Enable A NYCAS T RP v6 function
2. Configure ANY CAST RP v6
1. Enable ANYCAST RP v6 function
Global Configuration Mode
ipv6 pim anycast-rp
no ipv6 pim anycast-rp
2. Configure ANYCAS T RP v6
(1) Configure RP candidate
Global Configuration Mode
ipv6 pim rp-candidate {vlan<vlan-id>
|loopback<index> |<ifname>}
[<A:B::C:D>][<priori ty>]
no ipv6 pim rp-candidate
(2) Configure self-rp-address (the RP communication address of this router)
Global Configuration Mode
ipv6 pim anycast-rp self-rp-addre ss
A:B::C:D
no ipv6 pim anycast-rp self-rp-addre ss
Command
Command
Command
Explanation
Enable ANY CAST RP function. (necessary)
The no operation will globally disable the
ANYCAS T RP function.
Explanation
Now, the PIM-SM has allowed the Loopback
interface to be a RP candidate.(necessary )
Please pay attention to that, ANYCAS T RP
protocol can configure the Loopback interface
or a regular three-layer VLA N interface to be
the RP candidate. In mak e sure that P IM
routers in the network can find where the RP
locates, the RP candidat e interface should be
added into the router.
No operation will cancel the RP candidate
configured on this router.
Explanation
Configure the self-rp-address of this router (as a
RP). This address can be used to exclusively
identify this router when communicating with
other RP.(necessary)
the effect of self-rp-addre ss refers to two
respects:
1 Once this router (as a RP) receives the register
message from a DR unicast, it needs to forward
the register message to all the other RP in the
network, notifying them of the state of source
(S.G). While forwarding the register message,
this router will change the source address of it
into self-rp-address.
2 Once this router(as a RP) rec eives a register
44-13