Dcscm Configuration Examples - Planet XGS3-42000R User Manual

[no] ip multica st de stination-control
<1-4094> <macaddr> acce ss-group
<6000-7999>
[no] ip multica st de stination-control
<IPA DDRESS/M> access-group
<6000-7999>
3． Multicast Strategy Configuration
Multicast Strategy uses the manner of specifying priority for specified multicast data to achieve and guarantee
the effects the specific user requires. It is noticeable that multicast data can not get a special care all along
unless the data are transmitted at TRUNK port. The configuration is very simple, it has only one command, i.e.
to set priority for the specified multicast. The commands are as follows:
Global Configuration Mode
[no] ip multica st policy <IPA DDRESS/M>
<IPA DDRESS/M> cos <priority>

43.8.3 DCSCM Configuration Examples

1． Source Control
In order to prevent an Edge Switch from putting out multicast data ad asbitsium, we configure Edge Switch so
that only the switch at port Ethernet 1/5 is allowed to transmit multicast, and the data group must be 225.1.2.3.
Also, switch connected up to port Ethernet1/10 can transmit multicast data without any limit, and we can make
the following configuration.
EC(config)#access-list 5000 permit ip any host 225.1.2.3
EC(config)#access-list 5001 permit ip any any
EC(config)#ip multicast source-control
EC(config)#interface ethernet1/5
EC(Config-If-Ethernet1/5)#ip multicast source-control access-group 5000
EC(config)#interface ethernet1/10
EC(Config-If-Ethernet1/10)#ip multicast source-cont rol access-group 5001
2． Destination Control
We want to limit users with address in 10.0.0.0/8 network segment from entering the group of 238.0.0.0/8, so
we can make the following configuration:
Firstly enable IGMP snooping in the VLA N it is located (Here it is assumed to be in VLA N2)
EC(config)#ip igmp snooping
EC(config)#ip igmp snooping vlan 2
After that, configure relative destination control access-list, and configure specified IP address to use that
access-list.
Command
Used to configure the rules destination
control uses to specify VLAN-MAC, the
NO form cancels the configuration.
Used to configure the rules destination
control uses to specified IP address/net
mask, the
configuration.
Configure multicast strategy, specify
priority for sources and groups in
specific range, and the range is <0-7>.
43-41
NO form cancels
Explanation
the