Global Mode - Planet XGS3-42000R User Manual

3.2.1.3 Global Mode

Ty pe the config command under Admin Mode will enter the Global Mode prompt "XGS3-42000R(config)#".
Use the exit command under other configuration modes such as Port Mode, VLAN mode will return to Global
Mode.
The user can perform global configuration settings under Global Mode, such as MAC Table, Port Mirroring,
VLAN creation, IGMP Snooping start and STP, etc. And the user can go further to Port Mode for configuration
of all the interfaces.

Interface Mode
Use the interface command under Global Mode can enter the interface mode specified. Chassis Switch
provides three interface type: 1. VLAN interfac e; 2. Ethernet port; 3. port-channel, accordingly the three
interface configuration modes.
Interface Type
VLAN Interface Ty pe interface vlan <Vlan-id>
command under Global Mode.
Ethernet Port Ty pe interface ethernet
<interface-list> command
under Global Mode.
port-channel Ty pe interface port-channel
<port-channel-number>
command under Global Mode.

VLAN Mode
Using the vlan <vlan-id>
VLAN Mode the us er can configure all member ports of the corresponding V LAN. Run the exit command
to exit the VLAN Mode to Global Mode.

DHCP Addre ss Pool Mode
Ty pe the ip dhcp pool <name>
prompt "XGS3-42000R(config-<name>-dhcp)#". DHCP address pool properties can be configured under
DHCP Address Pool Mode. Run the exit command to exit the DHCP Address Pool Mode to Global Mode.

Route Mode
Routing Protocol
RIP Routing
Protocol
OSPF Routing
Protocol
BGP Routing
Protocol
Entry
command under Global Mode can enter the corresponding VLA N Mode. Under
command under Global Mode will enter the DHCP Address Pool Mode
Entry
Type router rip command
under Global Mode.
Type router ospf command
under Global Mode.
Type router bgp <AS
mumber> command under
Global Mode.
Operates
Configure switch IPs, etc
Configure supported
duplex mode, speed, etc.
of Ethernet Port.
Configure port-channel
related settings such as
duplex mode, speed, etc.
Operates
Configure RIP
protocol parameters.
Configure OSPF
protocol parameters.
Configure BGP
protocol parameters.
3-35
Exit
Use the exit command
to return to Global
Mode.
Use the exit command
to return to Global
Mode.
Use the exit command
to return to Global
Mode.
Exit
Use the exit
command to return
to Global Mode.
Use the exit
command to return
to Global Mode.
Use the exit
command to return
to Global Mode.