Planet XGS3-42000R User Manual page 51

male duplex LC connector type.

To connect to 1000Base-LX SFP transceiver, use the Single-mode fiber cable-with one side must
be male duplex LC connector type.

Approved PLANET XFP Transceivers
PLANE T Chassis Switch supports both Single-mode and Multi-mode XFP transceiver. The following list of
approved PLANE T XFP transceivers is correct at the time of publication:
Gigabit SFP Transceiver modules:
■ MTB-XS R XFP (10GBASE-SR XFP transceiver / Multi-mode / 850nm / 300m)
■ MTB-XLR XFP (1000BASE-LR XFP transceiver / Single-mode / 1310nm / 10km)
It recommends using PLA NE T XFPs on the Chassis Switch. If you insert a XFP
transceiver that is not supported, the Chassis Switch will not recognize it.
Before connect the other Chassis Switches, workstation or Media Converter.
1. Make sure both side of the XFP transceiver are with the same media type, for example: 10GB ase-S R to
10GB ase-S R, 10GB ase-LR to 10GBase-LR.
2. Check the fiber-optic cable type match the XFP transceiver model.

To connect to 10GB ase-S R XFP transceiver, use the Multi-mode fiber cable-wit h one side must be
male duplex LC connector type.

To connect to 10GBase-LR XFP transceiver, use the Single-mode fiber cable-with one side must be
male duplex LC connector type.

Connect the fiber cable
1. Attach the duplex LC connector on the net work cable into the SFP / XFP transceiver.
2. Connect the other end of the cable to a device – switches with SFP / XFP installed, fiber NIC on a
workstation or a Media Converter.
3. Check the LNK/ACT LE D of the SFP / XFP slot on the front of the Chassis Switch. Ensure that the SFP /
XFP transceiver is operating correctly.
4. Check the Link mode of the SFP / XFP port if the link failed. Co works with some fiber-NICs, Switch or
Media Converters, set the Link mode to "1000 Force" / "10G" is needed.

Remove the transceiver module
1. Make sure there is no network activity by consult or check with the network administrator. Or through the
management interface of the switch/converter (if available) to disable the port in advanc e.
2. Remove the Fiber Optic Cable gently.
3. Turn the handle of the MGB / MTB module to horizontal.
4. Pull out the module gently through the handle.
2-21