Typical Examples Ofs Ntp Configuration - Planet XGS3-42000R User Manual

63.2 Typical Examples of SNTP Configuration
SNTP/NTP SNTP/NTP
SERVER SERVER
... ...
SWITCH SWITCH SWITCH
Typical SNTP Configuration
Figure 63-2-1
All switches in the autonomous zone are required to perform time synchronization, which is done through two
redundant S NTP/NTP servers. For time to be synchronized, the net work must be properly configured. There
should be reachable route between any switch and the two SNTP/ NTP servers.
Example: Assume the IP addresses of the S NTP/NTP servers are 10.1.1.1 and 20.1. 1.1, respectively, and
SNTP/NTP server function (such as NTP master) is enabled, then configurations for any switch should like
the following:
XGS 3-42000R#config
XGS 3-42000R(config)#sntp server 10.1.1. 1
63-2