Planet XGS3-42000R User Manual page 283

Layer 3 SwitchA
Enable RIPng protocol
SwitchA(config)#router IP v6 rip
SwitchA(config-router)#exit
Configure the IP v6 address in vlan1 and configure vlan1 to run RIP ng
SwitchA#config
SwitchA(config)# interface Vlan1
SwitchA(config-if-Vlan1)# IP v6 address 2000:1:1::1/64
SwitchA(config-if-Vlan1)#IP v6 rout er rip
SwitchA(config-if-Vlan1)#exit
Configure the IP v6 address in vlan2 and configure vlan2 to run RIP ng
SwitchA(config)# interface Vlan2
SwitchA(config-if-Vlan2)#IP v6 address 2001:1:1::1/64
SwitchA(config-if-Vlan2)#IP v6 rout er rip
SwitchA(config-if-Vlan2)#exit
Configure the interface vlan1 do not send RIPng messages to SwitchC
SwitchA(config)#
SwitchA(config-router)#passive-interface Vlan1
SwitchA(config-router)#exit
Layer 3 S witchB
Enable RIPng protoc ol
SwitchB (config)#router IP v6 rip
SwitchB (config-router-rip)#exit
Configure the IP v6 address and interfaces of Ethernet port vlan1 to run RIP ng
SwitchB#config
SwitchB(config)# interface Vlan1
SwitchB(config-if)# IP v6 address 2001:1:1::2/64
SwitchB(config-if)#IP v6 router rip
SwitchB(config-if)exit
Layer 3 SwitchC
Enable RIPng protocol
SwitchC(config)#router IP v6 rip
SwitchC(config-router-rip)#exit
Configure the IP v6 address and interfaces of Ethernet port vlan1 to run RIP ng
SwitchC#config
SwitchC(config)# interface Vlan1
SwitchC(config-if)# IP v6 address 2000:1:1::2/64
SwitchC(config-if)#IP v6 router rip
SwitchC(config-if)exit
36-7