Planet XGS3-42000R User Manual page 434

1）Configure the interval of MLD sending query message
2）Configure the maximum response time of MLD query
3）Configure overtime of MLD query
3、 Shut down MLD Protoc ol
1. Start MLD Protocol
There is no special command for starting MLD Protoc ol on EDGECORE series layer 3 switches. MLD
Protocol will aut omatically start up as long as any IP v6 multicast protocol is started on corresponding
interface.
Global Mode
Ipv6 pim multicast-routing
Port Configuration Mode
ipv6 pim dense-mode | ipv6 pim
sparse-mode
2. Configure MLD auxiliary parameters
（1）Configure MLD group parameters
1） Configure MLD group filter conditions
Port Configuration Mode
ipv6 mld access-group
<acl_nam e>
no ipv6 mld access-group
（2）Configure MLD Query parameters
1）Configure interval time for MLD to send query messages
2）Configure the maximum response time of MLD query
3）Configure the overtime of MLD query
Port Configuration Mode
ipv6 mld query-interval <time_val>
no ipv6 mld query-interval
Command
Command
Command
Command
Explanation
To start Global IP v6 Multicast Protocol, the
precondition of starting MLD Protoc ol. The NO
operation of corresponding command shuts ipv6
multicast protocol and MLD Protocol. (Required)
Explanation
Start MLD Protocol. The NO operation of
corresponding command shuts MLD Protocol.
(Required)
Explanation
Configure the filter conditions of interface for
MLD group; the NO operation of t his command
cancels filter conditions.
Explanation
Configure the interval of MLD query messages
sent periodically; the NO operation of this
command restores the default value.
44-25