Planet XGS3-42000R User Manual page 362

configuration mode and then enabling P IM-SM for specific interfaces in the interface configuration mode.
Global Mode
ip pim multicast-routing
And then turn on PIM-SM switch on the interface
Interface Configuration Mode
ip pim sparse-mode
2. Configure static multica st routing entries
Global Configuration Mode
ip mroute
<ifname> <.ifname>
no ip mroute
<A.B.C.D> [<ifname> <.ifname>]
3. Configure additional parameters for PIM-SM
(1) Configure parameters for PIM-SM interfaces
1) Configure the interval for PIM-SM hello messages
Interface Configuration Mode
ip pim hello-interval <interval>
no ip pim hello-interval
2) Configure the hold time for P IM-SM hello messages
Interface Configuration Mode
ip pim hello-holdtime <value>
no ip pim hello-holdtime
3) Configure ACL for PIM-SM neighbors
Interface Configuration Mode
Command
Command
Command
<A.B.C.D> <A.B.C.D>
<A.B.C.D>
Command
Command
Command
Explanation
To enable the PIM-SM protocol for all the
interfaces (However, in order to make PIM-SM
work for specific interfaces, the
command should be issued).(Required)
Explanation
Enable PIM-SM Prot ocol of the interface.
(Required).
Explanation
To configure a static multicast routing entry. The
no form of this command will remove the
specified static multicast routing entry.
Explanation
To configure the interval for PIM-SM hello
messages. The no form of this command
restores the interval to the default value.
Explanation
To configure the value of the holdtime field in the
PIM-SM hello messages. The no form of this
command will restore the hold time to the default
value.
Explanation
43-10
following