Planet XGS3-42000R User Manual page 319

4. Configure BGP Weights
BGP configuration mode
neighbor { <ip-address> | <TAG> } weight
<weight>
no neighbor { <ip-address> | <TAG> }
5. Configure BGP Rout e Filtering policy based on neighbor
BGP configuration mode
neighbor {<ip-address> |<TAG>} di stribute-list
{<1-199> |<1300-2699> |<WORD>} {in|out}
no neighbor {<ip-address> |<TAG>} di stribute-list
{<1-199> |<1300-2699> |<WORD>} {in|out}
6. Configure Next-Hop
1) Set Next-Hop as the switch's address
BGP configuration mode
neighbor { <ip-address> | <TAG> }
next-hop-self
no neighbor { <ip-address> | <TAG> }
next-hop-self
2）Cancel default Next-Hop through route map
Rout e mapped configuration command
set ip next-hop <ip-address>
no set ip next-hop
7. Configure EGBP Multi-Hop
If the connections with outer neighbors are not direct, the following command can configure neighbor
Multi-Hop.
BGP configuration mode
neighbor {<ip-address> |<TAG>} ebgp-multihop
[<1-255> ]
no neighbor {<ip-address> |<TAG>}
ebgp-multihop [<1-255>]
Command
Command
Command
Command
Command
Configure BGP neighbor weights;
the no neighbor { <ip-addre ss> |
<TAG> } command recovers default
weights.
Filter
updating information. The no
neighbor
<TAG>}
{<1-199> |<1300-2699> |
<WORD>} {in|out} command
cancels routing filter.
Explanation
While sending route Next-Hop s et Next-Hop
as the switch's address; the no neighbor
{ <ip-address> | <TAG> } next-hop-self
command cancels the setting.
Explanation
Set the Next-Hop attribute of outbound
route. The no set ip next-hop command
cancels this setting.
Configure the allowance of EBGP
connection with other networks
that are not connected directly;
the
39-6
Explanation
Explanation
neighbor routing
{<ip-address>
distribute-li st
Explanation
no neighbor
|