Configurate Chassis Switch Ip Addresses; Chassis Switch Ip Addresses Configuration Task List - Planet XGS3-42000R User Manual

terminal monitor
terminal no monitor
4.2.2.3 Typical SSH Server Configuration
Example1:
Requirement: Enable SSH server on the Chassis Switch, and run SSH2.0 client software such as Secure
shell client or putty on the terminal. Log on the switch by using the us ername and password from the client.
Configure the IP address, add SSH user and enable SSH service on the Chassis Switch. SSH2.0 client can
log on the switch by using the username and password to configure the Chassis Switch.
XGS 3-42000R(config)#ssh-server enable
XGS 3-42000R(config)#interface vlan 1
XGS 3-42000R(config-if-Vlan1)#ip address 100.100.100.200 255.255.255.0
XGS 3-42000R(config-if-Vlan1)#exit
XGS 3-42000R(config)#ssh-user test password 0 test
In IP v6 net works, the terminal should run IP v6-supporing SSH client software, such as putty6. Users should
make no modification to configurations on the Chassis Switch except allocating an IP v6 address for the local
host.

4.3 Configurate Chassis Switch IP Addresses

All Ethernet ports of Chassis Switch are default to Data Link layer ports and perform layer 2 forwarding. VLAN
interface represent a Lay er 3 interface function which can be assigned an IP address, which is also the IP
address of the switch. All VLAN interface related configuration commands can be configured under VLAN
Mode. Switch provides three IP address configuration methods:
 Manual
 BOOTP
 DHCP
Manual configuration of IP address is assign an IP address manually for the Chassis Switch.
In BOOTP/ DHCP mode, the Chassis Switch operates as a BOOTP/DHCP client, send broadcast packets of
BOOTP request to the BOOTP/DHCP servers, and the BOOTP/DHCP servers assign the address on
receiving the request. In addition, switch can act as a DHCP server, and dynamic ally assign network
parameters such as IP addresses, gateway addresses and DNS server addresses to DHCP clients DHCP
Server configuration is detailed in later chapters.

4.3.1 Chassis Switch IP Addresses Configuration Task List

1． Enable VLAN port mode
2． Manual configuration
3． BOOTP configuration
4． DHCP configuration
Display SSH debug information on the SSH client
side; the "no terminal monitor" command stops
displaying SSH debug information on the SSH
client side.
4-4