Table of Contents
Advertisement
R4(c onfig)#interface Vlan200
R4(Config-if-Vlan200)# ip address 100.2.2.1 255.255.255.0
R4(c onfig)#interface loopback 1
R4(Config-if-loopback1)# ip address 5.5.5.5 255.255.255.255
R4(c onfig)#router ospf 1
R4(c onfig-router)# ospf router-id 4. 4.4.4
R4(c onfig-router)# network 100.2.1.0/24 area 0
R4(c onfig-router)# network 100.2.2.0/24 area 0
On R1, show ip route, the following is displayed:
R1(c onfig)#show ip route
Codes: K - kernel, C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
* - candidat e default
C
1.1.1.1/32 is directly connected, Loopback1 tag:0
O
5.5.5.5/32 [110/3] via 100.1.1.2, Vlan100, 00:00:05
[110/3] via 100.1.2.2, Vlan200, 00:00:05
C
100.1.1.0/24 is directly connected, Vlan100 tag: 0
C
100.1.2.0/24 is directly connected, Vlan200 tag: 0
O
100.2.1.0/24 [110/2] via 100. 1.1.2, Vlan100, 00: 02:25 tag:0
O
100.2.2.0/24 [110/2] via 100. 1.2.2, Vlan200, 00: 02:25 tag:0
C
127.0.0.0/8 is directly connected, Loopback tag:0
Total routes are : 8 item(s)
tag:0
tag:0
42-4
Advertisement
Table of Contents
Troubleshooting
