Planet XGS3-42000R User Manual page 431

Global Configuration Mode
[no] ipv6 access-li st <9000-10099>
{deny|permit} {{< source/M>}|{host-source
<source-host-ip>}|any-source}
{{<destination/M>}|{host-de stination
<destination-host-ip>}|any-de stination}
The last step is to configure the rules to the specified source IP, sourc e VLAN MAC or the specified port. What
should be paid attention to is that only when the MLD-SNOOPING is enabled, these rules can be globally
used, or, only rules of sourc e IP can be us ed in MLD protocol. The following is the configuration command:
Port Mode
[no] ipv6 multicast de stination-control
access-group <9000-10099>
Global Configuration Mode
[no] ipv6 multicast de stination-control
<1-4094> <macaddr> acce ss-group
<9000-10099>
[no] ipv6 multicast de stination-control
<IPA DDRESS/M> access-group
<9000-100999>
3． The configuration of multica st policy
The multicast policy adopts the met hod of specifying a priority for the specified multicast data to meet the
user's particular demand, what should be paid attention to is that only when multicast data is transmitted in
TRUNK, can it be taken special care of. The configuration is quite simple, for only one command is needed,
that is set priority for the specified multicast, the following is the command:
Global Configuration Mode
[no] ipv6 multicast policy <IPADDRESS/M>
<IPA DDRESS/M> cos <priority>
Command
Command
Used to configure destination control
rules, these rules can only take effect
when applied to specified source IP,
VLAN-MA C or port. The no operation
of this rule will delete the specified
rule.
Explanation
Used to configure the destination control
rule t o a port, the no operation of this
command will cancel the configuration.
Used to configure the destination control
rules to the specified VLA N-MA C, the no
operation of this command will cancel
the configuration.
Used to configure the destination control
rules to the s pecified source IP v6
address/MASK, the no operation of this
command will cancel the configuration.
Configure multicast policy, set priority
for sources and groups in a specified
range, the priority valid range is 0 to 7.
44-22
Explanation