Planet XGS3-42000R User Manual page 480

dot1x macfilter enable
no dot1x macfilter enable
dot1x accept-mac
<mac-address> [interface
<interface-name> ]
no dot1x accept-mac
<mac-address> [interface
<interface-name> ]
dot1x eapor enable
no dot1x eapor enable
4) Configure IP v6 passthrough function of the port
Command
Global Mode
dot1x ipv6 passthrough
no dot1x ipv6 passthrough
4. Supplicant related property configuration
Command
Global Mode
dot1x max-req <count>
no dot1x max-req
dot1x re-authentication
no dot1x re-authentication
dot1x timeout quiet-period
<seconds>
no dot1x timeout
quiet-period
dot1x timeout re-authperiod
<seconds>
no dot1x timeout
re-authperiod
dot1x timeout tx-period
<seconds>
no dot1x timeout tx-period
dot1x re-authenticate
[interface <interface-name> ]
Enables the 802.1x address filter function in the switch; the
no command disables the 802.1x address filter function.
Adds 802.1x address filter table entry, the no command
deletes 802.1x filter address table entries.
Enables the EAP relay authentication function in the
switch; the no command
authentication.
Enables IP v6 passthrough function of global mode on a
switch, only applicable when access control mode is
userbased; the no operation of this command will disable
the function.
Sets the number of EAP request/MD5 frame to be sent
before the switch re-initials authentication on no supplicant
response, the no command restores the default setting.
Enables periodical supplicant authentication; the no
command disables this function.
Sets time to keep silent on port authentication failure; the
no command restores the default value.
Sets the supplicant re-authentication interval; the no
command restores the default setting.
Sets the interval for the supplicant to re-transmit EAP
request/identity frame; the no command restores the
default setting.
Enables IEEE 802.1x re-authentication (no wait timeout
requires) for all ports or a specified port.
47-15
sets EAP
Explanation
Explanation
local end