Examples Of Ipv4 Radius Applications - Planet XGS3-42000R User Manual

# Set the link type of the port as access mode.
XGS 3-42000R(config-If-Ethernet1/2)#switch-port mode access
# Set the access control mode on the port as portbased.
XGS 3-42000R(config-If-Ethernet1/2)#dot1x port-method portbased
# Set the access control mode on the port as auto.
XGS 3-42000R(config-If-Ethernet1/2)#dot1x port-control auto
# Set the port's Guest VLAN as 100.
XGS 3-42000R(config-If-Ethernet1/2)#dot1x guest-vlan 100
XGS 3-42000R(config-If-Ethernet1/2)#exit
Using the command of show running-config or show interface ethernet 1/2, users can check the
configuration of Guest VLAN. When there is no online user, no failed user authentication or no user gets
offline s uccessfully, and more authentication-t riggering messages (EAP-Request/Identity) are sent than the
upper limit defined, users can check whet her the Guest VLA N configured on the port takes effect with the
command show vlan id 100.

47.3.2 Examples of IPv4 Radius Applications

The P C is connecting to port 1/2 of the switch; IEEE 802.1x authentication is enabled on port1/2; the access
mode is the default MAC-bas ed authentication. The switch IP address is 10.1.1.2. Any port other than port 1/2
is used to connect to RADIUS authentication server, whic h has an IP address of 10.1.1.3, and use the default
port 1812 for authentication and port 1813 for accounting. IEEE 802.1x authentication client software is
installed on the PC and is used in IEEE 802.1x authentication.
10.1.1.1
IEEE 802.1x Configuration Example Topology
Figure 47-3-3
10.1.1.2
Radius Server
10.1.1.3
47-18