Set Dap Auto Mode - D-Link DWS-1008 Cli Reference Manual

8 port 10/100 wireless switch with power over ethernet

Hide thumbs Also See for DWS-1008:

Table of Contents

Examples: The following command creates a profile for automatic Distributed AP

configuration:

DWS-1008# set dap auto

success: change accepted.

• set dap auto mode

• set dap auto persistent

• set dap auto radiotype

• set {ap | dap} bias

• set {ap | dap} blink

• set {ap | dap} group

• set {ap | dap} radio auto-tune max-power

• set {ap | dap} radio mode

• set {ap | dap} radio radio-profile

• set {ap | dap} upgrade-firmware

set dap auto mode

Enables an DWS-1008's profile for automatic Distributed AP configuration.

Syntax: set dap auto mode {enable | disable}

Defaults: The AP configuration profile is disabled by default.

Access: Enabled

Usage: You must use the set dap auto command to create the profile before you can enable it.

Examples: The following command enables the profile for automatic Distributed AP

configuration:

DWS-1008# set dap auto mode enable

success: change accepted.

D-Link DWS-1008 CLI Manual

Enables the AP configuration profile.

Disables the AP configuration profile.