D-Link DWS-1008 Cli Reference Manual page 55

Port Parameter
VLAN Membership
Spanning Tree Protocol
(STP)
802.1x
Port Groups
IGMP Snooping
Maximum user sessions
Examples: The following commands set port 2 for access point model DWL-8220AP, enables
PoE on the port:
DWS-1008# set port type ap 2 model DWL-8220AP poe enable
This may affect the power applied on the configured ports. Would you like to continue?
(y/n) [n]y
success: change accepted.
See Also:
• clear dap
• clear port type
• set {ap | dap} radio antennatype
• set dap
• set port type wired-auth
• set system countrycode
D-Link DWS-1008 CLI Manual
Removed from all VLANs. You cannot assign an AP access port to a VLAN. MSS
automatically assigns AP access ports to VLANs based on user traffic.
Not applicable.
Uses authentication parameters configured for users.
Not applicable.
Enabled as users are authenticated and join VLANs.
Not applicable
Setting