D-Link DWS-1008 Cli Reference Manual page 350

The table below lists the parameters controlled by a radio profile and their default values.
Parameter
active-scan
auto-tune
beacon-interval
countermeasures
dtim-interval
frag-threshold
max-rx-lifetime
max-tx-lifetime
preamble-length
qos-mode
rfid-mode
rts-threshold
service-profile
wmm-powersave
D-Link DWS-1008 CLI Manual
Default Value
enable
enable
100
Not configured
1
2346
2000
2000
short
wmm
disable
2346
No service profiles defined
disable
Radio Behavior When Parameter Set to Default Value
Sends probe any requests (probe requests with a
null SSID name) to solicit probe responses from
other access points.
Allows dynamic configuration of channel and power settings by
MMS.
Waits 100ms between beacons.
Does not issue countermeasures against any device.
Sends the delivery traffic indication map (DTIM) after every
beacon.
Uses the short-retry-count for frames shorter than 2346 bytes
and uses the long-retry-count for frames that are 2346 bytes or
longer.
Allows a received frame to stay in the buffer for up to 2000ms (2
seconds).
Allows a frame that is scheduled for transmission to stay in the
buffer for up to 2000ms (2 seconds).
Advertises support for short 802.11b preambles, and generates
unicast frames with the preamble length specified by the client.
Note: This parameter applies only to 802.11b/g radios.
Classifies and marks traffic based on 802.1q and DSCP,
and optimizes forwarding prioritization of AP radios for Wi-Fi
Multimedia (WMM).
Radio does not funtion as a location reciever in an AreoScout
Visibility System.
Transmits frames longer than 2346 bytes by means of the
Request-to-Send/Clear-to-Send (RTS/CTS) method.
You must configure a service profile. The service profile sets the
SSID name and other parameters.
Requires clients to send a seperate PSpoll to retrieve each
unicast packet buffered by the AP.