System Services Commands - D-Link DWS-1008 Cli Reference Manual

System Services Commands

Use system services commands to configure and monitor system information for a DWS-1008 switch.
This chapter presents system services commands alphabetically. Use the following table to located
commands in this chapter based on their use.
System Identification
D-Link DWS-1008 CLI Manual
Configuration
Auto-Config
Display
Help
History
License
Technical Support
quickstart on page 18
set auto-config on page 27
clear banner motd on page 15
set banner motd on page 19
show banner motd on page 28
set confirm on page 20
set length on page 20
set prompt on page 22
set system name on page 27
set system location on page 27
set system contact on page 23
set system countrycode on page 23
set system idle-timeout on page 25
set system ip-address on page 26
show load on page 29
show system on page 30
clear system on page 16
clear prompt on page 15
help on page 17
history on page 18
clear history on page 15
set license on page 21
show licenses on page 29
show tech-support on page 32
1