D-Link DWS-1008 Cli Reference Manual page 444

Field
Bridge ID Priority
Bridge Max Age
Bridge Hello Time
Bridge Forward Delay
Port
Vlan
STP-State or Port-State
Cost
Prio
Portfast
See Also:
• show spantree blockedports
D-Link DWS-1008 CLI Manual
This switch's bridge priority.
This switch's maximum acceptable age for hello packets.
This switch's hello interval.
This switch's forwarding delay value.
Port number.
Note: Only network ports are listed. STP does not apply to access point ports or wired
authentication ports.
VLAN ID.
STP state of the port:
• Blocking—The port is not forwarding Layer 2 traffic but is listening to and forwarding
STP control traffic.
• Disabled—This state can indicate any of the following conditions:
• The port is inactive.
• The port is disabled.
• STP is enabled on the port but the port is not forwarding traffic. (The port is active
and enabled but STP has just started to come up.)
• Forwarding—The port is forwarding Layer 2 traffic.
• Learning—The port is learning the locations of other devices in the spanning tree
before changing state to forwarding.
• Listening—The port is comparing its own STP information with information in STP
control packets received by the port to compute the spanning tree and change state
to blocking or forwarding.
• STP Off—STP is disabled on the port.
STP cost of the port.
STP priority of the port.
State of the uplink fast convergence feature:
• Enabled
• Disabled
Description
1