D-Link DWS-1008 Cli Reference Manual page 322

When a static IP address is specified for a Distributed AP, there is no preconfigured DNS
information or DNS name for the DWS-1008 the Distributed AP attempts to use as its boot
device. If you configure a static IP address for a Distributed AP, but do not specify a boot device,
then the DWS-1008 switch must be reachable via subnet broadcast.
Examples: The following command configures Distributed AP 1 to use the DWS switch with
address 172.16.0.21 as its boot device.
DWS-1008# set dap 1 boot-switch switch-ip 172.16.0.21 mode enable
success: change accepted.
The following command configures Distributed AP 1 to use the DWS switch with the name dws2 as
its boot device. The DNS server at 172.16.0.1 is used to resolve the name of the DWS switch.
DWS-1008# set dap 1 boot-switch name dws2 dns 172.16.0.1 mode enable
success: change accepted.
See Also:
• clear dap boot-configuration
• set dap boot-ip
• set dap boot-vlan
• show dap boot-configuration
set dap boot-switch
Specifies 802.1Q VLAN tagging information for a Distributed AP.
Syntax: set dap dap-num boot-vlan vlan-tag tag-value [mode {enable | disable}]
Syntax: set dap dap-num boot-vlan mode {enable | disable}
dap dap-num
vlan-tag tag-value
mode {enable | disable}
Defaults: None.
Access: Enabled
D-Link DWS-1008 CLI Manual
Number of the Distributed AP for which you are specifying VLAN
information.
The VLAN tag value. You can specify a number from 1 – 4095.
Enables or disables use of the specified VLAN tag on the Distributed
AP.
1