D-Link DWS-1008 Cli Reference Manual page 360

The AP radio still buffers packets for all traffic priorities even if the client does not request
U-APSD for them. However, to retrieve buffered packets for priorities that are not using U-APSD,
a client must send a separate PSpoll for each buffered packet.
Syntax: set radio-profile name wmm-powersave {enable | disable}
name Radio profile name.
enable Enables U-APSD.
disable Disables U-APSD.
Defaults: U-APSD is disabled by default.
Access: Enabled.
Usage: U-APSD is supported only for QoS mode WMM. If WMM is not enabled on the radio
profile, use the set radio-profile qos-mode command to enable it.
Examples: The following command enables U-APSD on radio profile rp1:
DWS-1008# set radio-profile rp1 wmm-powersave enable
success: change accepted.
See Also:
• set radio-profile mode
• set radio-profile qos-mode
• show radio-profile
set service-profile attr
Configures authorization attributes that are applied by default to users accessing the SSID
managed by the service profile. These SSID default attributes are applied in addition to any
supplied by the RADIUS server or from the local database.
Syntax: set service-profile name attr attribute-name value
name
attribute-name value
D-Link DWS-1008 CLI Manual
Service profile name.
Name and value of an attribute you are using to authorize SSID
users for a particular service or session characteristic.