Set Fdb - D-Link DWS-1008 Cli Reference Manual

set fdb

Adds a permanent or static entry to the forwarding database.
Syntax: set fdb {perm | static} mac-addr port port-list vlan vlan-id [tag tag-value]
perm
static
mac-addr
port port-list
vlan vlan-id
tag tag-value VLAN tag value that identifies a virtual port. You can specify a number from 1
Defaults: None.
Access: Enabled.
Usage: You cannot add a multicast or broadcast address as a permanent or static FDB entry.
Examples: The following command adds a permanent entry for MAC address 00:11:22:aa:bb:cc
on ports 3 and 5 in VLAN blue:
DWS-1008# set fdb perm 00:11:22:aa:bb:cc port 3,5 vlan blue
success: change accepted.
The following command adds a static entry for MAC address 00:2b:3c:4d:5e:6f on port 1 in the
default VLAN:
DWS-1008# set fdb static 00:2b:3c:4d:5e:6f port 1 vlan default
success: change accepted.
See Also
• clear fdb
• show fdb
D-Link DWS-1008 CLI Manual
Adds a permanent entry. A permanent entry does not age out and remains in the
database even after a reboot, reset, or power cycle.
Adds a static entry. A static entry does not age out, but is removed from the
database after a reboot, reset, or power cycle.
Destination MAC address of the entry. Use colons to separate the octets (for
example, 00:11:22:aa:bb:cc).
List of physical destination ports for which to add the entry. A separate entry is
added for each port you specify.
Name or number of a VLAN of which the port is a member. The entry is added
only for the specified VLAN.
through 4093. If you do not specify a tag value, an entry is created for an untagged
interface only. If you specify a tag value, an entry is created only for the specified
tagged interface.