set system location
Stores location information for the DWS-1008 switch.
Syntax: set system location string
string
Defaults: None.
Access: Enabled.
To view the system location string, type the show system command.
Examples: To store the location of the switch in the switch's configuration, type the following
command:
DWS-1008# set system location first-floor-bldg3
success: change accepted.
See Also:
• clear system
• set system contact
• set system name
• show system
set system name
Changes the name of the switch from the default system name and also provides content for
the CLI prompt, if you do not specify a prompt.
Syntax: set system name string
string
Defaults: By default, the system name and command prompt have the same value. The factory
default for both is DWS-mmmm-nnnnnn, where mmmm is the model number and nnnnnn is the
last 6 digits of the 12-digit system MAC address.
Access: Enabled.
D-Link DWS-1008 CLI Manual
Alphanumeric string up to 256 characters long, with no blank spaces.
Alphanumeric string up to 256 characters long, with no blank spaces.