D-Link DWS-1008 Cli Reference Manual page 149

snmp-engine-id {ip ip-addr |
local | hex hex-string}
access {read-only | read-notify Specifies the access level of the user:
| notify-only | read-write |
notify-read-write}
D-Link DWS-1008 CLI Manual
Specifies a unique identifier for the SNMP engine.
To send informs, you must specify the engine ID of the
inform receiver.
To send traps and to allow get and set operations and so on,
specify local as the engine ID.
• hex hex-string—ID is a hexadecimal string.
• ip ip-addr—ID is based on the IP address of the station
running the management application. Enter the IP address
of the station. MSS calculates the engine ID based on the
address.
• local—Uses the value computed from the switch's system
IP address.
• read-only—An SNMP management application using the
string can get (read) object values on the switch but cannot
set (write) them.
• read-notify—An SNMP management application using the
string can get object values on the switch but cannot set
them. The switch can use the string to send notifications.
• notify-only—The switch can use the string to send
notifications.
• read-write—An SNMP management application using the
string can get and set object values on the switch.
• notify-read-write—An SNMP management application
using the string can get and set object values on the switch.
The switch can use the string to send notifications.
1