D-Link DWS-1008 Cli Reference Manual page 506

show snoop map
Shows the AP radios that are mapped to a specific snoop filter.
Syntax: show snoop map filter-name
filter-name Name of the snoop filter.
Defaults: None.
Access: Enabled.
Usage: To display the mappings for all snoop filters, use the show snoop command.
Examples: The following command shows the mapping for snoop filter snoop1:
DWS-1008# show snoop map snoop1
filter 'snoop1' mapping
Dap: 3 Radio: 2
See Also:
• clear snoop map
• set snoop map
• show snoop
show snoop stats
Displays statistics for enabled snoop filters.
Examples: show snoop stats [filter-name [dap-num [radio {1 | 2}]]]
filter-name
dap dap-num
radio 1
radio 2
Defaults: None.
Access: Enabled.
Usage: The AP retains statistics for a snoop filter until the filter is changed or disabled. The AP
then clears the statistics.
Examples: The following command shows statistics for snoop filter snoop1:
DWS-1008# show snoop stats snoop1
Filter
=====================================================
snoop1
D-Link DWS-1008 CLI Manual
Name of the snoop filter.
Number of a Distributed AP to which the snoop filter is mapped.
Radio 1 of the AP.
Radio 2 of the AP. (This option does not apply to single-radio models.)
Dap Radio Rx Match
3 1 96
Tx Match Dropped
4 0
Stop-After
stopped
0