Set Spantree Portvlancost; Set Spantree Portvlanpri - D-Link DWS-1008 Cli Reference Manual

set spantree portvlancost

Changes the cost of a network port or ports on paths to the STP root bridge for a specific VLAN
on an switch.
Syntax: set spantree portvlancost port-list cost cost {all | vlan vlan-id}
port-list List of ports. MSS applies the cost change to all the specified ports.
cost cost
Numeric value. You can specify a value from 1 through 65,535. STP selects
lower-cost paths over higher-cost paths.
all Changes the cost on all VLANs.
vlan vlan-id VLAN name or number. MSS changes the cost on only the specified VLAN.
Defaults: The default port cost depends on the port speed and link type.
Access: Enabled.
Examples: The following command changes the cost on ports 3 and 4 to 20 in VLAN mauve:
DWS-1008# set spantree portvlancost 3,4 cost 20 vlan mauve
success: change accepted.
See Also:
• clear spantree portcost
• clear spantree portvlancost
• set spantree portcost
• show spantree
• show spantree portvlancost

set spantree portvlanpri

Changes the priority of a network port or ports for selection as part of the path to the STP root
bridge, on one VLAN or all VLANs.
Syntax: set spantree portvlanpri port-list priority value {all | vlan vlan-id}
port-list
priority value
all
vlan vlan-id
D-Link DWS-1008 CLI Manual
List of ports. MSS changes the priority on the specified ports.
Priority value. You can specify a value from 0 (highest priority) through 255
(lowest priority).
Changes the priority on all VLANs.
VLAN name or number. MSS changes the priority on only the specified
VLAN.