Set Dap Auto - D-Link DWS-1008 Cli Reference Manual

set dap auto

Creates a profile for automatic configuration of Distributed APs.
Syntax: set dap auto
Defaults: None.
Access: Enabled.
The following Table lists the configurable profile parameters and their defaults. The only parameter
that requires configuration is the profile mode. The profile is disabled by default. To use the profile
to configure Distributed APs, you must enable the profile using the set dap auto mode enable
command.
The profile uses the default radio profile by default. You can change the profile using the set dap
auto radio radio-profile command. You can use set dap auto commands to change settings
for the parameters listed in the following table. (The commands are listed in the "See Also"
section.)
D-Link DWS-1008 CLI Manual
Parameter
AP Parameters
bias
blink
(Not shown in show dap config output)
force-image-download
group (load balancing)
mode
persistent
upgrade-firmware
(boot-download-enable)
Radio Parameters
radio num auto-tune max-power
radio num mode
radio num radio-profile
radiotype
Default Value
high
disable
None.
none
disabled
none
enable (YES)
default
enabled
default
11g (or 11b for country codes
where 802.11g is not allowed)
1