D-Link DWS-1008 Cli Reference Manual page 153

8 port 10/100 wireless switch with power over ethernet

Hide thumbs Also See for DWS-1008:

Table of Contents

set system ip-address

Configures the system IP address. The system IP address determines the interface or source IP

address MSS uses for system tasks, including the following:

• Topology reporting for dual-homed access points

• Default source IP address used in unsolicited communications such as AAA

accounting reports and SNMP traps

Syntax: set system ip-address ip-addr

Defaults: None.

Access: Enabled.

Usage: You must use an address that is configured on one of the switch's VLANs.

To display the system IP address, use the show system command.

Examples: The following commands configure an IP interface on VLAN taupe and configure the

interface to be the system IP address:

DWS-1008# set interface taupe ip 10.10.20.20/24

success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe

DWS-1008# set system ip-address 10.10.20.20

success: change accepted.