Set Port Poe - D-Link DWS-1008 Cli Reference Manual

A stream of large packets sent to an DWS-1008 port in such a configuration can cause forwarding
on the link to stop.
Examples: The following command disables autonegotiation on ports 1, 2, and 4 through 6:
DWS-1008# set port negotiation 1,2,4-6 disable
The following command enables autonegotiation on port 5:
DWS-1008# set port negotiation 5 enable

set port poe

Enables or disables Power over Ethernet (PoE) on ports connected to AP access points.
Caution! When you set the port type for AP use, you can enable PoE on the port. Use the
DWS-1008's PoE to power D-Link access points or PoE enabled devices only. If you enable PoE
on ports connected to other devices, damage can result.
Syntax: set port poe port-list enable | disable
port-list
enable
disable
Defaults: PoE is disabled on network and wired authentication ports. The state on access point
ports depends on whether you enabled or disabled PoE when setting the port type. See set
port type ap.
Access: Enabled.
Usage: This command does not apply to any gigabit Ethernet ports or to port 3 on the
DWS-1008 switch.
Examples: The following command disables PoE on ports 3 and 5, which are connected to an
access point:
D-Link DWS-1008 CLI Manual
List of physical ports. MSS disables or reenables PoE on all the specified
ports.
Enables PoE on the specified ports.
Disables PoE on the specified ports.
8