D-Link DWS-1008 Cli Reference Manual page 139

The following command configures community string switchmgr1 with access level notify-read-
write:
DWS-1008# set snmp community name switchmgr1 notify-read-write
success: change accepted.
See Also:
• clear snmp community
• set ip snmp server
• set snmp notify target
• set snmp notify profile
• set snmp protocol
• set snmp security
• set snmp usm
• show snmp community
set snmp notify profile
Configures an SNMP notification profile. A notification profile is a named list of all the notification
types that can be generated by a switch, and for each notification type, the action to take (drop
or send) when an event occurs.
You can configure up to ten notification profiles.
Syntax: set snmp notify profile {default | profile-name}
{drop | send} {notification-type | all}
default | profile-name
drop | send
notification-type
• APBootTraps—Generated when an access point boots.
• ApNonOperStatusTraps—Generated to indicate an AP radio is nonoperational.
• ApOperRadioStatusTraps—Generated when the status of an AP radio changes.
• APTimeoutTraps—Generated when an access point fails to respond to the switch.
• AuthenTraps—Generated when the switch's SNMP engine receives a bad community
string.
• AutoTuneRadioChannelChangeTraps—Generated when the RF Auto-Tuning feature
changes the channel on a radio.
D-Link DWS-1008 CLI Manual
Name of the notification profile you are creating or modifying. The
profile-name can be up to 32 alphanumeric characters long, with no
spaces.
To modify the default notification profile, specify default.
Specifies the action that the SNMP engine takes with regard to the
notifications you specify with notification-type or all.
Name of the notification type:
1