Set Radius Server - D-Link DWS-1008 Cli Reference Manual

set radius server

Configures RADIUS servers and their parameters. By default, the switch automatically sets all
these values except the password (key).
Syntax: set radius server server-name [address ip-address] [auth-port port-number]
[acct-port port-number] [timeout seconds] [retransmit number] [deadtime minutes]
[[key string] | [encrypted-key string]] [author-password password]
server-name
address
ip-address
auth-port
port-number
acct-port
port-number
timeout seconds
retransmit number
deadtime minutes
key string |
encrypted-key string
author-password
password
D-Link DWS-1008 CLI Manual
Unique name for this RADIUS server. Enter an alphanumeric string
of up to 32 characters, with no blanks.
IP address of the RADIUS server. Enter the address in dotted decimal
notation.
UDP port that the switch uses for authentication and authorization.
UDP port that the switch uses for accounting.
Number of seconds the switch waits for the RADIUS server to
respond before retransmitting. You can specify from 1 to 65,535
seconds.
Number of transmission attempts made before declaring an
unresponsive RADIUS server unavailable. You can specify from
1 to 100 retries.
Number of minutes the switch waits after declaring an unresponsive
RADIUS server unavailable before retrying that RADIUS server.
Specify between 0 (zero) and 1440 minutes (24 hours). A zero value
causes the switch to identify unresponsive servers as available.
Password (shared secret key) the switch uses to authenticate to
RADIUS servers. You must provide the same password that is defined
on the RADIUS server. The password can be 1 to 64 characters long,
with no spaces or tabs.
• Use the key option to enter the string in its unencrypted form.
MSS encrypts the displayed form of the string in show config and
show aaa output.
• To enter the string in its encrypted form instead, use the
encrypted-key option. MSS does not encrypt the string you enter,
and instead displays the string exactly as you enter it.
Number of minutes the switch waits after declaring an unresponsive
RADIUS server unavailable before retrying that RADIUS server.
Specify between 0 (zero) and 1440 minutes (24 hours). A zero value
causes the switch to identify unresponsive servers as available.