Snoop Commands - D-Link DWS-1008 Cli Reference Manual

Use snoop commands to monitor wireless traffic, by using a Distributed AP as a sniffing device. The
AP copies the sniffed 802.11 packets and sends the copies to an observer, which is typically a protocol
analyzer such as Ethereal or Tethereal.
This chapter presents snoop commands alphabetically. Use the following table to locate commands in
this chapter based on their use.
Remote monitoring (snooping)
clear snoop
Deletes a snoop filter.
Syntax: clear snoop filter-name
filter-name Name of the snoop filter.
Defaults: None.
Access: Enabled.
Examples: The following command deletes snoop filter snoop1:
DWS-1008# clear snoop snoop1
See Also:
• set snoop
• show snoop info
D-Link DWS-1008 CLI Manual

Snoop Commands

clear snoop on page 496
clear snoop map on page 497
set snoop on page 497
set snoop map on page 500
set snoop mode on page 501
show snoop on page 502
show snoop info on page 502
show snoop map on page 503
show snoop stats on page 503