clear spantree portcost
Resets to the default value the cost of a network port or ports on paths to the STP root bridge in
all VLANs on a DWS-1008 switch.
Syntax: clear spantree portcost port-list
port-list
Defaults: None.
Access: Enabled.
Usage: This command resets the cost in all VLANs. To reset the cost for only specific VLANs, use
the clear spantree portvlancost command.
Examples: The following command resets the STP port cost on ports 5 and 6 to the default
value:
DWS-1008# clear spantree portcost 5-6
success: change accepted.
See Also:
• clear spantree portvlancost
• set spantree portcost
• set spantree portvlancost
• show spantree
• show spantree portvlancost
clear spantree portpri
Resets to the default value the priority of a network port or ports for selection as part of the path
to the STP root bridge in all VLANs on a DWS-1008 switch.
Syntax: clear spantree portpri port-list
port-list
Defaults: None.
Access: Enabled.
Usage: This command resets the priority in all VLANs. To reset the priority for only specific
VLANs, use the clear spantree portvlanpri command.
Examples: The following command resets the STP priority on port 9 to the default:
DWS-1008# clear spantree portpri 9
success: change accepted.
D-Link DWS-1008 CLI Manual
List of ports. The port cost is reset on the specified ports.
List of ports. The port priority is reset to 32 (the default) on the specified
ports.