Access Point Commands - D-Link DWS-1008 Cli Reference Manual

Access Point Commands

Use DWL-8220AP access point commands to configure and manage DWL-8220AP access points. Be
sure to do the following before using the commands:
• Define the country-specific IEEE 802.11 regulations on the DWS-1008 switch.
• Install the DWL-8220AP access point and connect it to a port on the switch.
• Configure an DWL-8220AP access port (for a directly connected AP) or a Distributed AP).
Caution:
Changing the system country code after DWL-8220AP configuration disables
DWL-8220AP access points and deletes their configuration. If you change the country
code on a switch, you must reconfigure all DWL-8220AP access points.
clear {ap | dap} radio
Disables an DWL-8220AP radio and resets it to its factory default settings.
Syntax: clear {ap port-list | dap dap-num} radio {1 | 2 | all}
ap port-list
dap dap-num
radio 1
radio 2
radio all
Defaults: The clear ap radio command resets the radio to the default settings.
Usage: When you clear a radio, MSS performs the following actions:
• Clears the transmit power, channel, and external antenna setting from the radio.
• Removes the radio from its radio profile and places the radio in the default radio profile.
This command does not affect the PoE (Power over Ethernet) setting.
D-Link DWS-1008 CLI Manual
List of ports connected to the DWL-8220AP access point(s) on which to
reset a radio.
Number of a Distributed AP on which to reset a radio.
Radio 1 of the DWL-8220AP.
Radio 2 of the DWL-8220AP.
All radios on the DWL-8220AP.
0