D-Link DWS-1008 Cli Reference Manual page 529

The table below describes the fields in the display.
Field
BOOT Index
BOOT TYPE
DEVICE
HOST IP
LOCAL IP
GATEWAY IP
IP MASK
FILENAME
FLAGS
OPTIONS
See Also:
• change
• create
• delete
• dhcp
• next
D-Link DWS-1008 CLI Manual
Boot profile slot, which can be a number from 0 to 3.
Boot type:
• c—Compact flash. Boots using nonvolatile storage or a flash card.
• n—Network. Boots using a TFTP server.
Location of the system image file:
• c:—Nonvolatile storage area containing boot partition 0
• d:—Nonvolatile storage area containing boot partition 1
• e:—Primary partition of the flash card in the flash card slot
• f:—Secondary partition of the flash card in the flash card slot
• boot0—boot partition 0
• boot1—boot partition 1
When the boot type is Network, the device can be one of the following:
• mgmt or tsec0—The 10/100 port labelled Mgmt
For network booting, the IP address of the host where the system image
resides
For network booting, the IP address of the switch. If the DHCP option is enabled,
this does not need to be specified.
For network booting, the default router (gateway) used by the switch. If the
DHCP option is enabled, this does not need to be specified.
For network booting, the subnet mask. If the DHCP option is enabled, this does
not need to be specified.
System image file name.
Number representing the bit settings of boot flags to pass to the booted system
image.
String up to 128 bytes of boot options to pass to the booted system image.
Description