Set Prompt - D-Link DWS-1008 Cli Reference Manual

set prompt

Changes the CLI prompt for the DWS-1008 switch to a string you specify.
Syntax: set prompt string
string
Defaults: The factory default for the DWS switch prompt is DWS-mm-nnnnnn, where
mm is the model number and nnnnnn is the last 6 digits of the 12-digit system
MAC address.
Access: Enabled.
Usage: When you first log in for the initial configuration of the DWS switch, the
CLI provides an DWS-mmmm-nnnnnn> prompt. After you become enabled by typing
enable and giving a suitable password, the DWS-mmmm-nnnnnn# prompt is displayed.
If you use the set system name command to change the default system name,
MSS uses that name in the prompt, unless you also change the prompt with set
prompt.
Examples: The following example sets the prompt from DWS to happy_days:
DWS-1008# set prompt happy_days
success: change accepted.
happy_days#
See Also:
• clear prompt
• set system name
• show config
D-Link DWS-1008 CLI Manual
Alphanumeric string up to 32 characters long. To include spaces in the
prompt, you must enclose the string in double quotation marks ("").