Show Rfdetect Visible - D-Link DWS-1008 Cli Reference Manual

show rfdetect visible

Displays the BSSIDs discovered by a specific D-Link radio. The data includes BSSIDs transmitted
by other D-Link radios as well as by third-party access points.
Syntax: show rfdetect visible mac-addr
Syntax: show rfdetect visible ap mp-num [radio{1|2}]
Syntax: show rfdetect visible dap dap-num [radio{1|2}]
mac-addr
mp-num
dap-num
radio 1
radio 2
Defaults: None.
Access: Enabled.
Usage: If a D-Link radio is supporting more than one SSID, each of the corresponding BSSIDs
is listed separately.
Examples: To following command displays information about the rogues detected by radio 1 on
AP port 3:
DWS-1008# show rfdetect visible ap 3 radio 1
Total number of entries: 104
Flags: i = infrastructure, a = ad-hoc
c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)
Transmit MAC
-----------------
00:07:50:d5:cc:91 Cisco
00:07:50:d5:dc:78 Cisco
00:0a:5e:4b:4a:c8
00:0a:5e:4b:4a:ca
...
D-Link DWS-1008 CLI Manual
Base MAC address of the D-Link radio.
Note: To display the base MAC address of a D-Link radio, use the
show{ap|dap}status command.
Port connected to the AP access point for which to display neighboring
BSSIDs.
Number of a Distributed AP for which to display neighboring
BSSIDs.
Shows neighbor information for radio 1.
Shows neighbor information for radio 2. (This option does not apply
to single-radio models.)
Vendor Type Ch
------- ----- ---
intfr 6
intfr 6
3Com intfr 11
3Com intfr 11
RSSI Flags
---- ------ --------------------------------
-60 i----w r27-cisco1200-2
-82 i----w r116-cisco1200-2
-83 i----w trpz-voip
-85 i----- trpz-webaaa
SSID
8