Set Spantree Priority - D-Link DWS-1008 Cli Reference Manual

Defaults: The default STP priority for all network ports is 128.
Access: Enabled.
Examples: The following command sets the priority of ports 3 and 4 to 48 on VLAN mauve:
DWS-1008# set spantree portvlanpri 3-4 priority 48 vlan mauve
success: change accepted.
See Also:
• clear spantree portpri
• clear spantree portvlanpri
• set spantree portpri
• show spantree

set spantree priority

Changes the STP root bridge priority of a DWS-1008 switch on one or all of its VLANs.
Syntax: set spantree priority value {all | vlan vlan-id}
priority value
all
vlan vlan-id
Defaults: The default root bridge priority for the switch on all VLANs is 32,768.
Access: Enabled.
Examples: The following command sets the bridge priority of VLAN pink to 69:
DWS-1008# set spantree priority 69 vlan pink
success: change accepted.
See Also:
• show spantree
D-Link DWS-1008 CLI Manual
Priority value. You can specify a value from 0 through 65,535. The bridge
with the lowest priority value is elected to be the root bridge for the
spanning tree.
Changes the bridge priority on all VLANs.
VLAN name or number. MSS changes the bridge priority on
only the specified VLAN.
8