Save Trace; Set Trace Authentication - D-Link DWS-1008 Cli Reference Manual

save trace

Saves the accumulated trace data for enabled traces to a file in the switch's nonvolatile storage.
Syntax: save trace filename
filename Name for the trace file. To save the file in a subdirectory, specify the subdirectory
name, then a slash. For example: traces/trace1
Defaults: None.
Access: Enabled.
Examples: To save trace data into the file trace1 in the subdirectory traces, type the following
command:
DWS-1008# save trace traces/trace1

set trace authentication

Traces authentication information.
Syntax: set trace authentication [mac-addr mac-address] [port port-num]
[user username] [level level]
mac-addr mac-address Traces a MAC address. Specify a MAC address, using colons to
port port-num
user username
level level
Defaults: The default trace level is 5.
Access: Enabled.
Examples:
The following command starts a trace for information about user jose's
authentication:
DWS-1008# set trace authentication user jose
success: change accepted.
D-Link DWS-1008 CLI Manual
separate the octets (for example, 00:11:22:aa:bb:cc).
Traces a port number. Specify a port number between 1 and 22.
Traces a user. Specify a username of up to 32 alphanumeric characters
with no spaces.
Determines the quantity of information included in the output. You can
set the level with an integer from 1 to 10, where level 10 provides the
most information. Levels 1 through 5 provide user-readable information.
If you do not specify a level, level 5 is the default.