Show Port Status - D-Link DWS-1008 Cli Reference Manual

show port status

Displays configuration and status information for ports.
Syntax: show port status [port-list]
port-list List of physical ports. If you do not specify a port list, information is displayed for
all ports.
Defaults: None.
Access: All.
Examples: The following command displays information for all ports on a DWS-1008:
DWS-1008# show port status
Port Name
===============================================================
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
The table below describes the fields in this display.
Field
Port
Name
Admin
Oper
Config
Actual
Type
Media
D-Link DWS-1008 CLI Manual
Admin Oper
up up
up down
up down
up down
up down
up down
up down
up down
Port name. If the port does not have a name, the port number is listed.
Administrative status of the port:
• up—The port is enabled.
• down—The port is disabled.
Operational status of the port:
• up—The port is operational.
• down—The port is not operational.
Port speed configured on the port:
• 10—10 Mbps.
• 100—100 Mbps.
• auto—The port sets its own speed.
Speed and operating mode in effect on the port.
Port type:
• ap—AP access point port
• network—Network port
• wa—Wired authentication port
Link type:
• 10/100BaseTX—10/100BASE-T.
Config Actual
auto 100/full
auto
auto
auto
auto
auto
auto
auto
Description
Port number.
Type Media
network 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
network no connector
network no connector
8