D-Link DWS-1008 Cli Reference Manual page 249

set dot1x bonded-period
Changes the Bonded Auth™ (bonded authentication) period. The Bonded Auth period is the
number of seconds MSS allows a Bonded Auth user to reauthenticate.
Syntax: set dot1x bonded-period seconds
seconds
Defaults: The default bonded period is 0 seconds, which disables the feature.
Access: Enabled.
Usage: Normally, the Bonded Auth period needs to be set only if the network has Bonded Auth
clients that use dynamic WEP, or use WEP-40 or WEP-104 encryption with WPA or RSN. These
clients can be affected by the 802.1X reauthentication parameter or the RADIUS Session-Timeout
parameter.
D-Link recommends that you try 60 seconds, and change the period to a longer value only if
clients are unable to authenticate within 60 seconds.
The bonded authentication period applies only to 802.1X authentication rules that contain the
bonded option.
Examples: To set the bonded authentication period to 60 seconds, type the following
command:
DWS-1008# set dot1x bonded-period 60
success: change accepted.
See Also:
• clear dot1x bonded-period
• show dot1x
D-Link DWS-1008 CLI Manual
Number of seconds MSS retains session information for an
authenticated machine while waiting for a client to (re)authenticate
on the same machine. You can change the bonded authentication
period to a value from 1 to 300 seconds.