Show Ntp - D-Link DWS-1008 Cli Reference Manual

show ntp

Displays NTP client information.
Syntax: show ntp
Defaults: None.
Access: All.
Examples: To display NTP information for a DWS-1008 switch, type the following command:
DWS-1008> show ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Fri Feb 06 2004, 12:02:57
Timezone is set to 'PST', offset from UTC is -8:0 hours.
Summertime is enabled.
Last NTP update: Fri Feb 06 2004, 12:02:46
NTP Server
----------------------------------------------------------------------
192.168.1.5
The table below describes the fields in this display.
Field
NTP client
Current update-interval
Current time
Timezone
Summertime
Last NTP update
NTP Server
Peer state
Local state
D-Link DWS-1008 CLI Manual
Peer state
SYSPEER
State of the NTP client. The state can be one of the following:
• Enabled
• Disabled
Number of seconds between queries sent by the switch to the NTP servers for updates.
System time that was current on the switch when you pressed Enter after typing the
show ntp command.
Time zone configured on the switch. MSS offsets the time reported by the NTP server
based on the time zone.
Note: This field is displayed only if you change the time zone.
Summertime period configured on the switch. MSS offsets the system time +1 hour and
returns it to standard time for daylight savings time or a similar summertime period that
you set.
Note: This field is displayed only if you enable summertime.
Time when the switch received the most recent update from an NTP server.
IP address of the NTP server.
State of the NTP session from the point of view of the NTP server:
• CORRECT
• REJECT
• SELCAND
• SYNCCAND
• SYSPEER
State of the NTP session from the point of view of the switch's NTP client:
• INITED
• START
• SYNCED
Local State
SYNCED
Description
1